Home

Products

About the
Company


E-mail us

The New Pro Sheeter - 16" Electric Optical Sheeter



VIDEO

The Pro-Sheeter is a stand alone table top digital sheeter capable of optically reading and sheeting your label jobs.

Feed the label job through the guide and into the nip rollers. Line up the SmartMark™ optical sensor with the target color. Dial in the label size and cut offset from the label and press START. The Pro Sheeter will advance the roll until the scan sensor reads the target color. It will then advance it to the first desired cut and make a cut. Then it will move the labels to the second desired cut position and make the second cut. Then it returns to scan mode and scans for the next target.



Three programmable modes give you versatility to sheet most jobs.
Even if you haven't printed anything and you just want to make up to 1 meter sheets out of some roll stock... you can set the Pro Sheeter for "sheet mode" and it will feed and sheet the media in what ever length you dial in.
For printed jobs there are two modes. One for closely spaced labels and one for labels with larger gaps between the rows.
Even register and cut hard to read colors on mirrored or reflective media.
The SmartMark™ controller shown below has 5 programmable settings for reading all kinds of material with and without laminates. This easy to use and easy to teach controller helps you cut the hardest to read jobs.


SmartMark™ controller

Roll Slicer.
If you are looking for a "Roll Slicer" to complete your finishing system, look no further... Click here to find out more about the GMS Portable Roll Slicer.

From 16" wide webs to as small as the one pictured below, the Pro Sheeter does the job.


We thought we would give the Pro Sheeter what would normally be a laborus task of cutting individual labels from a small roll. The roll was 1.5" in width with a 1 inch red label pictured above.


You can see it above webbed from a GMS unwinder and into the sheeter via the sheeter guide.


Here's a shot of the output on the individual piece job.

Rewinders and Unwinders.
Rewinders and unwinders are very handy tools. They keep you from having to babysit in-feeds and output. They are pictured in the 2nd picture above and top picture.
Click here to find out more.

Email us for more information.

Content © 2003 Distribution Enterprises, Inc.
Gerber Edge® is a registered trademark of Gerber Scientific Products, Inc.